2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL REAR ENGINE OIL SEAL
  1. Apply MP grease to the lip of a new rear engine oil seal.

    NOTICE:
    1. Keep the lip free of foreign matter.
    2. Do not allow MP grease to contact the dust seal.

  1. A340243E01
    Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.
    SST
    09351-40010   (09351-04010, 09351-04020)
    Text in Illustration 
    *1
    Rear Oil Seal Retainer
    *2
    Rear Engine Oil Seal
    *a
    0 to 1.0 mm (0 to 0.0394 in.)

    NOTICE:
    1. The acceptable depth from the top of the rear engine oil seal retainer is 0 to 1.0 mm (0 to 0.0394 in.)
    2. Keep the lip free from foreign matter.
    3. Do not tap the rear engine oil seal at an angle.
    4. Make sure that the rear engine oil seal is properly installed.


2. INSTALL REAR END PLATE
  1. Install the rear end plate to the cylinder block sub-assembly with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


3. INSTALL FLYWHEEL SUB-ASSEMBLY

  1. A349457E01
    Using SST, hold the crankshaft pulley.
    SST
    09213-58014   (91551-80840)
    09330-00021  

  1. A346662E01
    Install the flywheel sub-assembly, the pump impeller drive plate and the rear drive plate spacer to the crankshaft with the 8 bolts.
    Text in Illustration 
    *1
    Flywheel Sub-assembly
    *2
    Pump Impeller Drive Plate
    *3
    Rear Drive Plate Spacer
    *a
    Engine Side
    *b
    Transmission Side

    NOTICE:
    1. Align either hole in the pump impeller drive plate and either hole in the rear drive plate spacer with the knock pin of the flywheel sub-assembly, and then install the flywheel sub-assembly, the pump impeller drive plate and the rear drive plate spacer to the crankshaft.
    2. Do not start the engine for at least 1 hour after installation.

    HINT:
    As the rear drive plate spacer and pump impeller drive plate are not reversible, be sure to install them in the direction shown in the illustration.

  1. A344484E01
    Install and uniformly tighten and tighten the 8 bolts in several steps in the sequence shown in the illustration.

    Torque:
    178 N*m{ 1815 kgf*cm , 131 ft.*lbf }

  1. Install the crankshaft pulley cover to the crankshaft pulley with the 4 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)
← REMOVAL (from Jan 2017)COMPONENTS (Jan 2017 – Nov 2017) →