2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)

2. REMOVE FLYWHEEL SUB-ASSEMBLY

  1. A343925
    Remove the 4 bolts and crankshaft pulley cover from the crankshaft pulley.

  1. A349457E01
    Using SST, hold the crankshaft pulley.
    SST
    09213-58014   (91551-80840)
    09330-00021  

  1. A344484
    Remove the 8 bolts, rear drive plate spacer, pump impeller drive plate and flywheel sub-assembly from the crankshaft.


3. REMOVE REAR END PLATE

  1. A396827
    Remove the bolt and rear end plate from the cylinder block sub-assembly.


4. REMOVE REAR ENGINE OIL SEAL

  1. A340242E01
    Using a knife, cut off the lip of the rear engine oil seal.
    Text in Illustration 
    *a
    Protective Tape
    *b
    Cloth
    *c
    Cut

  1. Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

    NOTICE:
    Be careful not to damage the crankshaft and rear engine oil seal retainer.

    HINT:
    1. After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.
    2. Tape the screwdriver tip before use.

← COMPONENTS (from Jan 2017)INSTALLATION (from Jan 2017) →