INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
5 (M-) - 4 (M+)
25°C
0.3 to 100 Ω
If the result is not as specified, replace the electric EGR control valve.Text in Illustration *a
Component without harness connected
(Electric EGR Control Valve Assembly)
| VISUALLY CHECK ELECTRIC EGR CONTROL VALVE ASSEMBLY |
Visually check the electric EGR control valve for deposits.
If there are deposits, clean the electric EGR control valve.- NOTICE:
- When cleaning the electric EGR control valve, make sure the valve is completely closed.
- Do not forcibly open the valve as it may be damaged or deformed.
- When cleaning the electric EGR control valve, use a piece of cloth soaked with cleaning solvent. Spraying the solvent directly onto this part or soaking the part in solvent may damage the part.
- When cleaning the electric EGR control valve, make sure the valve is completely closed.
Hold the electric EGR control valve up to a light, and then from the side indicated by the arrow in the illustration, visually check that there is no gap between the valve and body.

- OK:
- No light passes through (there is no gap between the valve and body).
- HINT:
- Light passes through part A shown in the illustration even if the valve is completely closed. This is not a problem.
