U0100 Lost Communication with ECM / PCM
Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016
Also covers:
- U0155 Lost Communication with Combination Meter
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
These DTCs are stored when there is a CAN communication error between the certification ECU (smart key ECU assembly) and the ECM or combination meter assembly.- HINT:
- When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
| DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
| U0100 |
CAN communication error between the certification ECU (smart key ECU assembly) and ECM (1-trip detection*) |
ECM |
Turn the engine switch on (IG) and wait 10 seconds or more. |
| U0155 |
CAN communication error between the certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection*) |
Combination meter assembly |
Turn the engine switch on (IG) and wait 10 seconds or more. |
- *: Only detected while a malfunction is present and the engine switch is on (IG)
| DTC Code |
Vehicle Condition when Malfunction Detected |
Fail-safe Function when Malfunction Detected |
| U0100 |
There is no effect on vehicle behavior. |
If the following conditions are met, it is determined that the malfunction is not in the direct line (NE) but in CAN communication.
|
| U0155 |
The warning (meter buzzer) does not sound and the meter does not indicate a warning. |
- |
- HINT:
Related Data List and Active Test Items DTC
Data List Item
Active Test Item
U0100
U0155
-
-
INSPECTION PROCEDURE
- NOTICE:
- When using the GTS with the vehicle engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
- After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
- When using the GTS with the vehicle engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
| 1. CHECK FOR DTC |
Note any DTCs that are output (Click here).
| NEXT | ||
| ||
