2014-2019 Hiace · Service Manual ENGINE

U0100 Lost Communication with ECM / PCM

Diagnostic trouble codes · Vehicles built Jan 2017 – Nov 2017

Also covers:

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

These DTCs are stored when there is a CAN communication error between the certification ECU (smart key ECU assembly) and the ECM or combination meter assembly.

HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
U0100
CAN communication error between the certification ECU (smart key ECU assembly) and ECM (1-trip detection*)
ECM
Turn the engine switch on (IG) and wait 10 seconds or more.
U0155
CAN communication error between the certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection*)
Combination meter assembly
Turn the engine switch on (IG) and wait 10 seconds or more.
  1. *: Only detected while a malfunction is present and the engine switch is on (IG)
Vehicle Condition and Fail-safe Function when Malfunction Detected 
DTC Code
Vehicle Condition when Malfunction Detected
Fail-safe Function when Malfunction Detected
U0100
There is no effect on vehicle behavior.
If the following conditions are met, it is determined that the malfunction is not in the direct line (NE) but in CAN communication.
  1. When the engine switch is pressed, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.
  2. When the engine switch is pressed and held, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.
If the following conditions are met, it is determined that there is a malfunction in both CAN communication and the direct line (NE).
  1. When the engine switch is pressed, the engine stops cranking after 6 seconds.
  2. When the engine switch is pressed and held, the engine remains cranking for up to 30 seconds.
U0155
The warning (meter buzzer) does not sound and the meter does not indicate a warning.
-

HINT:
Related Data List and Active Test Items 
DTC
Data List Item
Active Test Item
U0100
U0155
-
-


INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the vehicle engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.


1. CHECK FOR DTC
  1. Note any DTCs that are output (Click here).


NEXT

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)


← U0100 Lost Communication with ECM / PCM (+ U0155) (Apr 2016 – Dec 2016)U0100 Lost Communication with ECM / PCM (+ U0155) (from Dec 2017) →