2014-2019 Hiace · Service Manual CRUISE CONTROL SYSTEM

P0500 Vehicle Speed Sensor Malfunction

Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of this pulse signal.
DTC Code
DTC Detection Condition
Trouble Area
P0500
The vehicle speed signal from the skid control ECU is cut for 0.14 seconds or more while cruise control is in operation.
  1. Vehicle speed sensor signal circuit
  2. Vehicle speed sensor
  3. Combination meter assembly
  4. ECM

INSPECTION PROCEDURE

This DTC may be stored under the SFI system*1 or ECD system*2 at the same time. In that case, perform troubleshooting for the SFI system*1 or ECD system*2 first.
*1: for 2TR-FE
*2: for 1KD-FTV

1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).

  1. Check for DTCs (Click here).

    OK:
    DTC P0500 is not output.

Result 
Result
Proceed to
OK
A
NG (for 2TR-FE)
B
NG (for 1KD-FTV w/ DPF)
C
NG (for 1KD-FTV w/o DPF)
D


B
GO TO SFI SYSTEM (Click here)

C
GO TO ECD SYSTEM (Click here)

D
GO TO ECD SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P0500 Vehicle Speed Sensor Malfunction (Dec 2015 – Mar 2016)P0500 Vehicle Speed Sensor Malfunction (Jan 2017 – Nov 2017) →