P0500 Vehicle Speed Sensor Malfunction
Diagnostic trouble codes · Vehicles built Jan 2015 – Nov 2015
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of this pulse signal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0500 |
The vehicle speed signal from the skid control ECU is cut for 0.14 seconds or more while cruise control is in operation. |
|
INSPECTION PROCEDURE
This DTC may be stored under the SFI system*1 or ECD system*2 at the same time. In that case, perform troubleshooting for the SFI system*1 or ECD system*2 first.*1: for 2TR-FE
*2: for 1KD-FTV
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Perform the following to make sure the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs (Click here).
- OK:
- DTC P0500 is not output.
| Result |
Proceed to |
| OK |
A |
| NG (for 2TR-FE) |
B |
| NG (for 1KD-FTV) |
C |
|
|
||||
|
|
||||
| A | ||
| ||
