2014-2019 Hiace · Service Manual CRUISE CONTROL SYSTEM

Cruise SET Indicator Light Circuit

Circuit diagnosis · Vehicles built Jan 2015 – Nov 2015

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, the ECM sends the signal to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

INSPECTION PROCEDURE

NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.


1. PERFORM ACTIVE TEST USING GTS (CRUISE CONTROL SET INDICATOR LIGHT)
  1. Using the GTS, perform the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    Cruise control SET indicator light
    ON/OFF
    -

    OK:
    Indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. READ VALUE USING GTS (CRUISE CONTROL MAIN SWITCH)
  1. Using the GTS, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    SET/COAST Switch
    -SET switch signal / ON or OFF
    ON: -SET switch on
    OFF: -SET switch off
    -

    OK:
    The display is as specified in the normal condition column.

Result 
Result
Proceed to
OK
A
NG (for 1KD-FTV)
B
NG (for 2TR-FE)
C


B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise SET Indicator Light Circuit (Oct 2014 – Dec 2014)Cruise SET Indicator Light Circuit (Dec 2015 – Mar 2016) →