2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT DCU RELAY (DCU)

  1. A301376E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the DCU relay.


INSPECT EFI MAIN RELAY (EFI MAIN)

  1. A167865E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the EFI MAIN relay.


INSPECT EFI NO. 2 RELAY (EFI NO. 2)

  1. A167865E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the EFI NO. 2 relay.


INSPECT EDU RELAY (EDU)

  1. A167865E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the EDU relay.


INSPECT NOX RELAY (NOX)

  1. A167865E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the NOX relay.


INSPECT NO. 2 INTEGRATION RELAY

NOTICE:
  1. The IG2 relay is built into the No. 2 integration relay.
  2. Before performing the relay inspection for the relay of the No. 2 integration relay, inspect the IG2-MAIN fuse.

  1. Inspect the IG2 relay.

    1. A318538E05
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      12A-1 - 12D-1
      Battery voltage not applied to terminals 12D-2 and 12E-4
      10 kΩ or higher
      Battery voltage applied to terminals 12D-2 and 12E-4
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 2 Integration Relay)
      If the result is not as specified, replace the No. 2 integration relay.

← INSTALLATION (from Jan 2017)PRECAUTION (Oct 2014 – Dec 2014) →