2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL SENSOR BRACKET
  1. Install the 2 sensor brackets with the 2 nuts and bolt.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }


2. INSTALL NITROGEN OXIDES SENSOR
  1. Temporarily install the nitrogen oxides sensor.

  1. Install the controller portion with the 2 nuts, and then attach the connector and clamp.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. A398618E01
    Using SST, install the nitrogen oxides sensor.
    SST
    09224-00012  

    Torque:
    Specified tightening torque:
    55 N*m{ 561 kgf*cm , 41 ft.*lbf }

    Text in Illustration 
    *a
    Torque Wrench Fulcrum Length

    NOTICE:
    1. Replace with a new part if it is dropped or if it receives a strong impact.
    2. Complete the installation so that there is no tension or slack in the harness of the nitrogen oxides sensor, and there is no interference.

    HINT:
    1. Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (Click here).
    2. When using SST (fulcrum length of 30 mm (1.181 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 49 N*m (502 kgf*cm, 36 ft.*lbf)


3. INSTALL NO. 1 FRONT FLOOR HEAT INSULATOR
  1. Install the No. 1 front floor heat insulator with the 3 bolts.

    Torque:
    17 N*m{ 168 kgf*cm , 12 ft.*lbf }

← REMOVAL (from Jan 2017)ON-VEHICLE INSPECTION (from Jan 2017) →