REMOVAL
Removal / installation · Vehicles built from Jan 2017
| 1.
REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR |
 |
- Remove the 3 bolts and No. 1 front floor heat insulator.
| 2.
REMOVE NITROGEN OXIDES SENSOR |
 |
- CAUTION:
- To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
- Remove the 2 nuts, detach the connector and clamp, and then disconnect the harness and controller portion.
- Using SST, remove the nitrogen oxides sensor.
- SST
- 09224-00012
| 3.
REMOVE SENSOR BRACKET |
 |
Remove the 2 nuts, bolt and 2 sensor brackets.