REMOVAL
Removal / installation · Vehicles built from Oct 2014
- NOTICE:
- When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
- After removing the fuel inlet pipe, clean it with a brush and compressed air.
- When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FUEL SUPPLY PUMP ASSEMBLY |
| 3. REMOVE FUEL TEMPERATURE SENSOR |
- NOTICE:
- Before replacing the fuel temperature sensor, be sure to clean the surrounding area.
- When replacing the fuel temperature sensor, make sure that your hands are clean and do not use gloves, etc.
- Before replacing the fuel temperature sensor, be sure to clean the surrounding area.
Mount the fuel supply pump in a vise between aluminum plates.
Using SST, remove the fuel temperature sensor.

- SST
- 09922-10010
Remove the gasket from the fuel temperature sensor.
