REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE AUTOMATIC LIGHT CONTROL SENSOR (for LHD) |
Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the automatic light control sensor.

- HINT:
- Protective tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape
Disconnect the connector.
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD) |
Put protective tape around the instrument panel finish panel end LH.

Using a moulding remover B, detach the 3 claws and remove the instrument panel finish panel end LH.
Disconnect the connector.
Text in Illustration *1
Protective Tape
| 3. REMOVE AUTOMATIC LIGHT CONTROL SENSOR (for RHD) |
Detach the 2 claws and remove the automatic light control sensor.

