The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
Perform the Active Test according to the display on the GTS.
Immobiliser
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator light
ON/OFF
-
OK:
Security indicator light can be turned on and off using the GTS.