2014-2019 Hiace · Service Manual SECURITIES

Security Indicator Light Does not Blink

Circuit diagnosis · Vehicles built Oct 2014 – Mar 2016

Versions by build date: Oct 2014 – Mar 2016 from Apr 2016

DESCRIPTION

The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.

WIRING DIAGRAM

B271007E43

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, refer to Service Bulletin.
  2. When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.


1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Immobiliser / Active Test.

  1. Perform the Active Test according to the display on the GTS.

    Immobiliser 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    -

    OK:
    Security indicator light can be turned on and off using the GTS.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. Disconnect the H60 transponder key ECU assembly connector.

  1. Disconnect the H20 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H60-8 (IND) - H20-29 (LP)
    Always
    Below 1 Ω
    H60-8 (IND) - Body ground
    Always
    10 kΩ or higher
    H20-29 (LP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TRANSPONDER KEY ECU ASSEMBLY (TERMINAL IND)
  1. Connect the H60 transponder key ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H20-29 (LP) - Body ground
    Key not in ignition key cylinder
    Pulse generation
    Key in ignition key cylinder
    Below 1 V



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE COMBINATION METER ASSEMBLY (SECURITY INDICATOR LIGHT) (Click here)


← Key Cannot be Registered (from Oct 2014)Security Indicator Light Does not Blink (from Apr 2016) →