Combination Meter ECU Communication Stop Mode
Circuit diagnosis · Vehicles built from Apr 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 from Apr 2016
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Combination Meter ECU Communication Stop Mode |
Either condition is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the combination meter assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H20-21 (E1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
H20-1 (L) - Body ground
Always
11 to 14 V
H20-2 (IG+) - Body ground
Ignition switch ON
11 to 14 V
| *a |
Rear view of wire harness connector (to Combination Meter Assembly) |
|
|
||||
| OK | ||
| ||
