2014-2019 Hiace · Service Manual COMMUNICATION SYSTEM

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 from Apr 2016

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
Either condition is met:
  1. "Combination Meter" is not displayed on "Bus Check".
  2. "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside combination meter assembly
  2. Combination meter assembly

WIRING DIAGRAM

C265646E08

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)

  1. C240157E24
    Disconnect the combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H20-21 (E1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H20-1 (L) - Body ground
    Always
    11 to 14 V
    H20-2 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Rear view of wire harness connector
(to Combination Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← ECM Communication Stop Mode (from Jan 2017)Combination Meter ECU Communication Stop Mode (Jan 2015 – Mar 2016) →