2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

E213665E01
  1. Check the rear height control sensor sub-assembly LH.

    1. Connect 3 dry batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      2 (SHRR) - 1 (SHG)
      High (+)
      Approximately 4.5 V
      Normal
      Approximately 2.5 V
      Low (-)
      Approximately 0.5 V

      NOTICE:
      1. Do not apply a voltage of more than 6 V.
      2. Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.
      If the result is not as specified, replace the height control sensor sub-assembly LH.

      Text in Illustration 
      *a
      Component without harness connected
      (Rear Height Control Sensor Subassembly LH)
      *b
      Low (-)
      *c
      Normal
      *d
      High (+)

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →