2014-2019 Hiace · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT BRAKE MASTER CYLINDER RESERVOIR
  1. Disconnect the connector from the brake master cylinder reservoir.

  1. Measure the resistance between the terminals after gradually draining brake fluid.

    Float position: top (Normal condition):
    10 kΩ or higher

    Float position: bottom (Abnormal condition):
    Below 1 Ω

    HINT:
    If the value is not specified, replace the brake master cylinder reservoir.

← COMPONENTS (from Jan 2015)REMOVAL (Oct 2014 – Dec 2014) →