2014-2019 Hiace · Service Manual ENGINE

P0630 VIN not Programmed or Mismatch - ECM / PCM

Diagnostic trouble codes · Vehicles built from Jan 2017

DESCRIPTION

DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.
P0630 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch ON for 5 seconds or more
Either of the following conditions is met (1 trip detection logic):
  1. The VIN or frame number is not stored in the ECM.
  2. The VIN or frame number input into the ECM is not accurate.
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)
  1. Connect an GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result: 
    Result
    Proceed to
    DTC P0630 is output
    A
    DTC P0630 and other DTCs are output
    B

    NOTICE:
    If P0630 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P0630 are set, check them first.

    HINT:
    If any DTCs other than P0630 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A


2. INPUT VIN OR FRAME NUMBER
  1. Input the VIN or frame number. (Click here).


NEXT

END


← P062F Internal Control Module EEPROM Error (from Jan 2017)P064C Glow Plug Control Module (+ 9 more codes) (from Jan 2017) →