2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch connector.

  1. Start the engine.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Engine stopped
    Below 1 Ω
    Engine idling
    10 kΩ or higher

    If the result is not as specified, replace the engine oil pressure switch assembly.

  1. Connect the engine oil pressure switch connector.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →