INSPECTION
Inspection · Vehicles built from Jan 2017
| INSPECT ENGINE OIL LEVEL SENSOR |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
On at below 40°C
Below 1 Ω
Off at below 40°C
Below 1 Ω
On at 60°C or higher
Below 1 Ω
Off at 60°C or higher
10 kΩ or higher
Text in Illustration *a
Component without harness connected
(Engine Oil Level Sensor)
*b
On
*c
Off
- CAUTION:
- Do not put your hands in the water warmed up during the inspection.
- Touching the hot water may result in burns.
- Do not put your hands in the water warmed up during the inspection.
- NOTICE:
- When checking the engine oil level sensor in water, do not allow water to contact the terminals. After completing the check, dry the engine oil level sensor.
- HINT:
- In addition to a level switch, the oil level sensor also has a temperature switch. Therefore, make sure to check the oil level sensor at both high and low temperatures.
- If the result is not as specified, replace the engine oil level sensor.
- In addition to a level switch, the oil level sensor also has a temperature switch. Therefore, make sure to check the oil level sensor at both high and low temperatures.
