REMOVAL
Removal / installation · Vehicles built from Jan 2017
| 1. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 6 bolts and No. 2 engine under cover.

| 2. DRAIN ENGINE OIL |
Remove the oil filler cap sub-assembly.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Clean and install a new gasket and the oil pan drain plug.
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
| 3. REMOVE ENGINE OIL LEVEL SENSOR |
Disconnect the engine oil level sensor connector.
Remove the 4 bolts and engine oil level sensor from the oil pan sub-assembly.

