ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2017
| CHECK INJECTOR ASSEMBLY |
Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.
Allow the engine to idle for 1 minute or more.
Connect the GTS to the DLC3.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Injection Volume and Injector Feedback Val. #1 to #4.
Read the values when the engine is idling.
Check that the "Injector Feedback Val. #1 to #4" values are within the specification.
- Standard:
Tester Display
Engine Condition
Specified Condition
Injection Volume
Idling
3 to 10 mm3/st
Injector Feedback Val. #1
Injector Feedback Val. #2
Injector Feedback Val. #3
Injector Feedback Val. #4
Idling
-3.0 to 3.0 mm3/st
| INJECTOR COMPENSATION CODE |
- HINT:
- If the injector compensation code is not correctly registered, it may cause malfunctions.
Read the injector compensation code.
(Click here)
Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.
(Click here)
