REMOVAL
Removal / installation · Vehicles built from Jan 2017
| 1. REMOVE SEAT TRACK COVER LH |
Using a clip remover, remove the clip.

Detach the claw and remove the seat track cover LH.
| 2. REMOVE FRONT SEAT ASSEMBLY RH |
Move the front seat assembly fully forward.

Remove the 2 bolts on the rear side of the seat.
Move the front seat assembly to the rearmost position.
Remove the 2 bolts on the front side of the seat.
Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.
Disconnect the front seat inner belt assembly connector.
Remove the front seat assembly.
| 3. REMOVE FRONT DOOR SCUFF PLATE RH |
| 4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Fold back the floor carpet.
Remove the 5 bolts and engine service hole sub cover sub-assembly.
| 5. REMOVE DIFFERENTIAL PRESSURE SENSOR |
Disconnect the connector from the differential pressure sensor.

Remove the bolt and differential pressure sensor from the pipe clamp.
Slide the 2 clamps and disconnect the 2 air hoses from the No. 1 vacuum pipe and No. 2 vacuum pipe.

Slide the 2 clamps and remove the 2 air hoses from the differential pressure sensor.

