2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT DIFFERENTIAL PRESSURE SENSOR
  1. Connect the GTS to the DLC3.

  1. Remove the front seat assembly RH.

  1. Remove front door scuff plate RH.

  1. Remove engine service hole sub cover sub-assembly.

  1. Slide the clamp and disconnect the air hose from the differential pressure sensor.

  1. A396480E01
    Install SST to the differential pressure sensor.
    SST
    09992-00242  

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine / Data List / DPF Differential Pressure.

  1. A396481E01
    Apply pressure to the differential pressure sensor assembly.
    Text in Illustration 
    *a
    Pressure

  1. Check the pressure value of the differential pressure sensor.

    Standard pressure:
    Approximately the same pressure as the applied pressure is indicated on the GTS.

    NOTICE:
    Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

    If the result is not as specified, check the differential pressure sensor circuit.

  1. Remove SST from the differential pressure sensor.

  1. Connect the air hose to the differential pressure sensor, and slide the clamp to secure the hose.

  1. Install engine service hole sub cover sub-assembly.

  1. Install front door scuff plate RH.

  1. Install the front seat assembly RH.

← COMPONENTS (from Jan 2017)REMOVAL (from Jan 2017) →