2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. REMOVE NO. 2 ENGINE UNDER COVER
  1. Remove the 6 bolts and No. 2 engine under cover from the body.


2. DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

NOTICE:
  1. Check for dirt or mud on the urea injector set and around the urea tube connector before disconnection. Clean if necessary.
  2. In order to prevent the urea injector set interior portion from drying, perform installation and removal work as quickly as possible.

  1. Disconnect the urea tube with heater assembly from the urea injector set.

    1. A396468
      Detach the lock claw by lifting up the cover.
      Text in Illustration 
      V100135
      Lift Up

    2. A396469
      Pinch the retainer of the urea tube connector, and then pull the urea tube connector off of the urea tube with heater assembly.
      Text in Illustration 
      V100135
      Pinch
      V100136
      Pull

      NOTICE:
      1. If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the urea tube connector.
      2. Be sure to disconnect the urea tube connector by hand.
      3. Check for foreign matter in the urea injector set and around the urea tube connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube connector.
      4. Put the urea injector set and urea tube connector ends in plastic bags to prevent damage and foreign matter contamination.


3. REMOVE UREA INJECTOR SET

  1. A396470
    Disconnect the connector from the urea injector set.

  1. A396471
    Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.

← COMPONENTS (from Jan 2017)INSPECTION (from Jan 2017) →