2014-2019 Hiace · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2017


1. REMOVE END COVER

  1. C334225
    Using a T30 "TORX" socket wrench, remove the 5 screws and end cover.

    NOTICE:
    1. Hold the pump so that the pump installation surface, fitting parts and oil pipe will not be damaged.
    2. As the housing deforms when force is applied, do not clamp the housing with a tool such as a vise.
    3. Securely fit the T30 "TORX" socket wrench to the screws.
    4. Do not drop the end cover.
    5. Do not damage the end cover.

  1. C334226E01
    Using a screwdriver with its tip wrapped with protective tape, remove the No. 1 O-ring.
    Text in Illustration 
    *a
    Protective Tape

    NOTICE:
    Do not damage the groove.


2. REMOVE VACUUM PUMP VANE

  1. C334227
    Remove the vacuum pump vane together with the 2 vacuum pump vane caps.

    NOTICE:
    1. When reusing the vacuum pump vane and vacuum pump vane caps, make sure to make a note of the installation position and orientation.
    2. Do not drop the vacuum pump vane or vacuum pump vane caps.

  1. C169339E05
    Remove the 2 vacuum pump vane caps from the vacuum pump vane.
    Text in Illustration 
    *1
    Vacuum Pump Vane Cap
    *2
    Vacuum Pump Vane

    NOTICE:
    1. When reusing the vacuum pump vane and vacuum pump vane caps, make sure to make a note of the installation positions and orientation.
    2. Do not drop the vacuum pump vane and vacuum pump vane caps.

← REMOVAL (from Jan 2017)INSPECTION (from Jan 2017) →