2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2017

HINT:
The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 mile) and replace parts as necessary.


1. REMOVE ENGINE ASSEMBLY
(Click here)

2. INSTALL ENGINE ASSEMBLY TO ENGINE STAND

NOTICE:
  1. Pay attention to the angle of the sling device as the engine assembly or engine hangers may be damaged or deformed if the angle is incorrect.
  2. With the exception of installing the engine assembly to an engine stand or removing the engine assembly from an engine stand, do not perform any work on the engine assembly while it is suspended, as doing so is dangerous.

  1. Install the engine assembly to an engine stand with the bolts.

  1. Remove the engine sling device and chain block.

  1. Remove the 3 bolts, upper No. 1 engine hanger, and No. 2 engine hanger from the engine assembly.


3. DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE

  1. C374024
    Disconnect the No. 1 vacuum transmitting hose from the vacuum pump assembly.


4. REMOVE VACUUM PUMP ASSEMBLY

  1. C374025
    Remove the 3 bolts and vacuum pump assembly from the engine assembly.

  1. Remove the No. 2 and No. 3 O-rings from the vacuum pump assembly.


5. REMOVE CAMSHAFT OIL SEAL RETAINER
(Click here)

6. REMOVE VACUUM PUMP UNION
  1. Mount the vacuum pump assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the vacuum pump assembly.

  1. Remove the union bolt, vacuum pump union and 2 gaskets from the vacuum pump assembly.

← ON-VEHICLE INSPECTION (from Jan 2017)DISASSEMBLY (from Jan 2017) →