Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _078379 NAVIGATION / MULTI INFO DISPLAY _0380007 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.


·

When performing the following work, the navigation system may restart when turning the ignition switch ACC (due to radio and display receiver assembly and navigation ECU certification).

-

Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.

-

The radio and display receiver assembly or navigation ECU replacement or removal and installation.



Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION


PROCEDURE

Hide 33622 1.DISCONNECT NO. 1 SHIFT LEVER KNOB COVER (for Automatic Transmission)

Hide 33504F 2.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58840Q 3.REMOVE SHIFTING HOLE COVER ASSEMBLY (for Manual Transmission)

Hide 35970F 4.REMOVE POSITION INDICATOR HOUSING ASSEMBLY (for Automatic Transmission)

Hide 55405B 5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55410C 6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 7.REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET

a.
E416296

Remove the 2 bolts.


b.
E416297

Remove the 2 bolts.


c.
E417039C01
0,0 0,0 false
V113146

Place Hands Here
V113147

Remove in this Direction


Place both hands at the position shown in the illustration, pull in the direction indicated by the arrow to detach the guide and remove the display and navigation assembly with bracket.


d.

Disconnect each connector.

HINT:

When disconnecting each connector, do not remove the navigation wire.



Hide 86842 8.REMOVE NO. 1 NAVIGATION WIRE

a.
E416303

Disconnect the 3 connectors and remove the No. 1 navigation wire.


Hide 86211 9.REMOVE NO. 1 RADIO BRACKET

a.
E415125

Remove the 5 screws and No. 1 radio bracket.


Hide 86212 10.REMOVE NO. 2 RADIO BRACKET

a.
E415124

Remove the 5 screws and No. 2 radio bracket.


Hide 86841 11.REMOVE NAVIGATION ECU