This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit | ·
Harness or connector ·
Speakers ·
Radio and Display Receiver Assembly |
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for Standard Roof | A |
| for High Roof | B |
A
B
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 4 Speakers | A |
| Other than above | B |
A
B
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the R3 and R13 front No. 1 speaker assembly connectors.
Disconnect the Z1 and Z2 roof speaker assembly (for Standard Roof) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-1 (FR+) or R3-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-6 (FR-) or R3-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-2 (FL+) or R13-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-7 (FL-) or R13-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-4 (RR+) or Z1-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) or Z1-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) or Z2-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) or Z2-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for Standard Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for Standard Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 4 Speakers | A |
| for 6 Speakers | B |
| Other than above | C |
A
B
C
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the R3 and R13 front No. 1 speaker assembly connectors.
Disconnect the Z1 and Z2 roof speaker assembly (for High Roof) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-1 (FR+) or R3-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-6 (FR-) or R3-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-2 (FL+) or R13-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-7 (FL-) or R13-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-4 (RR+) or Z1-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) or Z1-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) or Z2-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) or Z2-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the R3 and R13 front No. 1 speaker assembly connectors.
Disconnect the Z1 and Z2 roof speaker assembly (for High Roof) connectors.
Disconnect the a3 and a4 roof speaker assembly (for High Roof, 6 Speakers) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-1 (FR+) or R3-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-6 (FR-) or R3-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-2 (FL+) or R13-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-7 (FL-) or R13-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-4 (RR+) or a3-4 (+TW) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) or a3-2 (-TW) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) or a4-4 (+TW) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) or a4-2 (-TW) - Body ground | Always | 10 kΩ or higher |
| a3-3 (TWR+) or Z1-2 (+) - Body ground | Always | 10 kΩ or higher |
| a3-1 (TWR-) or Z1-1 (-) - Body ground | Always | 10 kΩ or higher |
| a4-3 (TWL+) or Z2-2 (+) - Body ground | Always | 10 kΩ or higher |
| a4-1 (TWL-) or Z2-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the roof speaker assembly (for High Roof, 6 Speakers) with a known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Connect all the connectors to the roof speaker assemblies that were disconnected.
When there is a possibility that either the right or left roof speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the R3 and R13 front No. 1 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-1 (FR+) or R3-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-6 (FR-) or R3-1 (-) - Body ground | Always | 10 kΩ or higher |
| O8-2 (FL+) or R13-2 (+) - Body ground | Always | 10 kΩ or higher |
| O8-7 (FL-) or R13-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG