The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the roof speaker assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Airbag System)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE ROOF HEADLINING ASSEMBLY
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>REMOVAL
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
4.REMOVE ROOF SPEAKER WITH BRACKET
for Standard Roof:
|
Bolt |
|
Connector |
Detach the clamp and disconnect the connector.
Remove the 2 bolts.
Detach the clip and guide and remove the roof speaker with bracket.
for High Roof:
|
Bolt |
|
Connector |
Detach the clamp and disconnect the connector.
Remove the 2 bolts.
Detach the guide and remove the roof speaker with bracket.
86160Q
5.REMOVE ROOF SPEAKER ASSEMBLY
for Standard Roof:
Remove the 2 bolts and roof speaker assembly.
for High Roof:
Remove the 2 bolts and roof speaker assembly.
86160Q
6.REMOVE ROOF SPEAKER ASSEMBLY (for Standard Roof, 6 Speakers)
Disconnect the connector.
Remove the 2 screws.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
Detach the claw and guide and remove the roof speaker assembly.
| *A | for LH Side | *B | for RH Side |
7.REMOVE ROOF SPEAKER WITH BRACKET (for High Roof, 6 Speakers)
Disconnect the connector.
Remove the 2 screws.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
Detach the claw and guide and remove the roof speaker with bracket.
| *A | for LH Side | *B | for RH Side |
86160Q
8.REMOVE ROOF SPEAKER ASSEMBLY (for High Roof, 6 Speakers)
Remove the 2 screws and roof speaker assembly from No. 1 speaker mounting bracket.
9.REMOVE SCREW GROMMET (for High Roof, 6 Speakers)
Perform this procedure only when replacing the screw grommet.
Detach the claw and remove the 2 screw grommets.