If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for Standard Roof | A |
| for High Roof | B |
A
B
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 4 Speakers | A |
| Other than above | B |
A
B
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly | A |
| Roof speaker assembly (for Standard Roof) | B |
If sound cannot be heard from any speaker, inspect all of them.
A
B
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the Z1 and Z2 Roof speaker assembly (for Standard Roof) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-4 (RR+) - Z1-2 (+) | Always | Below 1 Ω |
| O8-9 (RR-) - Z1-1 (-) | Always | Below 1 Ω |
| O8-3 (RL+) - Z2-2 (+) | Always | Below 1 Ω |
| O8-8 (RL-) - Z2-1 (-) | Always | Below 1 Ω |
| O8-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for Standard Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for Standard Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 4 Speakers | A |
| for 6 Speakers | B |
| Other than above | C |
A
B
C
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly | A |
| Roof speaker assembly (for High Roof) | B |
If sound cannot be heard from any speaker, inspect all of them.
A
B
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the Z1 and Z2 Roof speaker assembly (for High Roof) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-4 (RR+) - Z1-2 (+) | Always | Below 1 Ω |
| O8-9 (RR-) - Z1-1 (-) | Always | Below 1 Ω |
| O8-3 (RL+) - Z2-2 (+) | Always | Below 1 Ω |
| O8-8 (RL-) - Z2-1 (-) | Always | Below 1 Ω |
| O8-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly | A |
| Roof speaker assembly (for High Roof) or Roof speaker assembly (for High Roof, 6 Speakers) | B |
If sound cannot be heard from any speaker, inspect all of them.
A
B
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the Z1 and Z2 Roof speaker assembly (for High Roof) connectors.
Disconnect the a3 and a4 Roof speaker assembly (for High Roof, 6 Speakers) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-4 (RR+) - a3-4 (+TW) | Always | Below 1 Ω |
| O8-9 (RR-) - a3-2 (-TW) | Always | Below 1 Ω |
| O8-3 (RL+) - a4-4 (+TW) | Always | Below 1 Ω |
| O8-8 (RL-) - a4-2 (-TW) | Always | Below 1 Ω |
| a3-3 (TWR+) - Z1-2 (+) | Always | Below 1 Ω |
| a3-1 (TWR-) - Z1-1 (-) | Always | Below 1 Ω |
| a4-3 (TWL+) - Z2-2 (+) | Always | Below 1 Ω |
| a4-1 (TWL-) - Z2-1 (-) | Always | Below 1 Ω |
| O8-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| O8-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| O8-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| O8-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| a3-3 (TWR+) - Body ground | Always | 10 kΩ or higher |
| a3-1 (TWR-) - Body ground | Always | 10 kΩ or higher |
| a4-3 (TWL+) - Body ground | Always | 10 kΩ or higher |
| a4-1 (TWL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Inspect the roof speaker assembly (for High Roof).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the roof speaker assembly (for High Roof, 6 Speakers) with a known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>REMOVAL
Check the malfunction disappears.
Connect all the connectors to the roof speaker assemblies that were disconnected.
When there is a possibility that either the right or left roof speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the O8 radio and display receiver assembly connector.
Disconnect the R3 and R13 front No. 1 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-1 (FR+) - R3-2 (+) | Always | Below 1 Ω |
| O8-6 (FR-) - R3-1 (-) | Always | Below 1 Ω |
| O8-2 (FL+) - R13-2 (+) | Always | Below 1 Ω |
| O8-7 (FL-) - R13-1 (-) | Always | Below 1 Ω |
| O8-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| O8-6 (FR-) - Body ground | Always | 10 kΩ or higher |
| O8-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| O8-7 (FL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG