Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (w/ Front Seat Side Airbag)
Be sure to read the Precaution section thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
71910E
3.REMOVE FRONT SEAT HEADREST ASSEMBLY RH
Remove the 2 front seat headrest assemblies RH.
71149Z
4.REMOVE BENCH TYPE FRONT SEAT LEG COVER
Remove the bolt.
Operate the seat track adjusting handle RH and move the front seat assembly RH forward.
|
Place Hands Here |
|
Remove in this Direction |
Place your hands at the position shown in the illustration and pull in the removal direction and detach the clip, claw and guide and remove the front seat inner leg cover.
71139T
5.REMOVE FRONT SEAT REAR LEG COVER RH
|
Place Hands Here |
|
Remove in this Direction |
Place your hands at the position shown in the illustration and pull in the removal direction and detach the clip and guide and remove the front seat rear leg cover RH as shown in the illustration.
6.REMOVE FRONT SEAT ASSEMBLY RH
Remove the 3 bolts.
Operate the seat track adjusting handle RH and move the front seat assembly RH backward.
Remove the 2 bolts.
w/ Front Seat Side Airbag:
Disconnect the front seat airbag assembly connector under the front seat assembly RH.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector:
w/ Seat Belt Warning System:
Disconnect the connector under the front seat assembly RH.
Remove the front seat assembly RH.
2 or more people are required when carrying the front seat assembly RH out of the vehicle.
Protect the front seat leg.
Be careful not to damage the front seat assembly RH, body exterior or body interior.