The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head sub-assembly disassembly/reassembly are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transmission is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
13711
1.REMOVE INTAKE VALVE
Using SST, compress the inner compression spring and remove the valve spring retainer locks.
Remove the valve spring retainer, inner compression spring and intake valve.
Arrange the removed parts in the correct order.
13715
2.REMOVE EXHAUST VALVE
Using SST, compress the inner compression spring and remove the valve spring retainer locks.
Remove the valve spring retainer, inner compression spring and exhaust valve.
Arrange the removed parts in the correct order.
13711E
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seals.
13734
4.REMOVE VALVE SPRING SEAT
Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.
11117P
5.REMOVE NO. 1 STRAIGHT SCREW PLUG
| *A | for Bank 1 |
| *B | for Bank 2 |
If water leaks from a straight screw plug or the plug is corroded, replace it.
Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets.
11117Q
6.REMOVE NO. 2 STRAIGHT SCREW PLUG
| *A | for Bank 1 |
| *B | for Bank 2 |
If water leaks from a straight screw plug or the plug is corroded, replace it.
Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.
11117R
7.REMOVE NO. 3 STRAIGHT SCREW PLUG
| *A | for Bank 1 |
| *B | for Bank 2 |
If water leaks from a straight screw plug or the plug is corroded, replace it.
Using a 10 mm hexagon wrench, remove the 8 No. 3 straight screw plugs and 8 gaskets.
8.REMOVE UNION
It is not necessary to remove the union unless it is being replaced.
9.REMOVE STUD BOLT
If the stud bolt is deformed or the threads are damaged, replace it.