The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake booster assembly removal/installation are shown below.
Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
47201
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
73900
3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
44773F
4.SEPARATE UNION TO CHECK VALVE HOSE
Slide the clip and disconnect the union to check valve hose from the brake booster assembly.
82111
5.SEPARATE ENGINE ROOM MAIN WIRE
Disconnect the connector from the vacuum warning switch assembly.
31481K
6.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE (for Manual Transmission)
7.SEPARATE BRAKE LINE
| *a | for Automatic Transmission |
| *b | for Manual Transmission |
for Manual Transmission:
Disengage the 3 clamps to remove the brake tube clamp from the brake lines and clutch line.
Do not damage or deform the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
for Automatic Transmission:
Disengage the 2 clamps to remove the brake tube clamp from the brake lines.
Do not damage or deform the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
| *a | for Manual Transmission |
| *b | for Automatic Transmission |
for Manual Transmission:
Disengage the 2 clamps and separate the brake lines and clutch line from the brake tube clamp.
Do not damage or deform the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
for Automatic Transmission:
Disengage the clamp and separate the brake line from the brake tube clamp.
Do not damage or deform the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
Disengage the clamp and remove the brake tube clamp from the vehicle body.
8.REMOVE BRAKE PEDAL RETURN SPRING
47264A
9.REMOVE PUSH ROD PIN
44610
10.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts and brake booster assembly from the vehicle body.
Do not apply excessive force to the brake lines.
44785
11.REMOVE BRAKE BOOSTER GASKET