Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 1GD-FTV)
RM35X0E _54 Brake _078668 BRAKE SYSTEM (OTHER) _0381545 VACUUM PUMP(for 1GD-FTV) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1GD-FTV)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 55701J 2.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 3. OPERATION CHECK

a.

Disconnect the vacuum hose from the vacuum pump assembly.


b.

Slide the clip and disconnect the vacuum hose from the vacuum pump assembly.


c.
C412540C01
0.49,0.594 0.708,0.365 0.708,0.365 0.875,0.365 true 1,1.281 1.125,0.958 1.125,0.958 1.208,0.958 true 0.938,0.26 1.167,0.479 0.229,0.219 10 true *a 1.281,0.885 1.5,1.104 0.219,0.219 10 true *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


d.

Start the engine and warm it up for more than 2 minutes.


e.

With the engine idling, check the negative pressure of the vacuum pump assembly.

Standard pressure:

More than 86.7 kPa (650 mmHg, 25.6 in.Hg)


If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (for 1GD-FTV)>INSPECTION

HINT:

Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.



f.

Remove the vacuum gauge from the vacuum pump assembly.


g.

Connect the vacuum hose to the vacuum pump assembly, and slide the clip to secure it.


Hide 55701J 4.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 5.INSTALL WINDSHIELD WIPER MOTOR AND LINK