INITIALIZATION
Before replacing the ECM, refer to the Service Bulletin (for Immobiliser System).
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
When disconnecting and reconnecting the battery.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
WHEN USING GTS
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One to drive the vehicle, and another to operate the GTS.