The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the glow plug assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Make sure to wear protective gloves when performing work to avoid burns.
When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
| Common rail assembly | ·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.
Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.
Make sure foreign matter does not enter the fuel path.
1. WARM UP ENGINE
To protect the glow plug assembly from damage, before removing the glow plug assembly, make sure to warm up the engine.
2. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
23810A
4.REMOVE COMMON RAIL ASSEMBLY
19871
5.REMOVE NO. 1 GLOW PLUG CONNECTOR
Make sure to wear protective gloves when performing work to avoid burns.
Using an E8 "TORX" socket wrench, remove the stud bolt from the intake manifold.
Remove the 4 glow plug screw grommets.
Remove the 4 nuts and No. 1 glow plug connector.
19850
6.REMOVE GLOW PLUG ASSEMBLY
Make sure to wear protective gloves when performing work to avoid burns.
Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.