The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51406A
3.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)
52618
4.REMOVE LOWER FRONT BUMPER ABSORBER
51405A
5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
28100
6.REMOVE STARTER ASSEMBLY
Open the starter terminal cap.
Remove the nut and disconnect the starter wire.
Disconnect the starter assembly connector.
for Automatic Transmission:
Remove the nut, 2 bolts and starter assembly.
for Manual Transmission:
Remove the 2 nuts and disconnect the wire harness clamp bracket from the clutch release cylinder assembly.
Remove the 2 bolts and disconnect the clutch release cylinder assembly.
Remove the 2 bolts and starter assembly and disconnect the clutch flexible hose bracket.