Perform "Inspection After Repair" after replacing the fuel delivery pipe with sensor assembly LH.
Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
23809K
1.INSTALL FUEL PIPE PLUG SUB-ASSEMBLY
Perform "Inspection After Repair" after replacing the fuel delivery pipe with sensor assembly LH.
Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Install a new O-ring, new No. 1 fuel injector back-up ring, new No. 2 fuel injector back-up ring and new No. 3 fuel injector back-up ring to the fuel pipe plug sub-assembly as shown in the illustration.
| *1 | Fuel Pipe Plug Sub-assembly | *2 | No. 1 Fuel Injector Back-up Ring |
| *3 | No. 2 Fuel Injector Back-up Ring | *4 | No. 3 Fuel Injector Back-up Ring |
| *5 | O-ring | - | - |
| *a | Opening | *b | Overlapped |
| *c | Stretched | *d | Correct |
| *e | Incorrect | - | - |
Check that there is no foreign matter or damage on the O-ring groove of the fuel pipe plug sub-assembly.
Check that the No. 1 fuel injector back-up ring and No. 3 fuel injector back-up ring are installed in the correct orientation.
Make sure that the No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring, No. 3 fuel injector back-up ring and O-ring are installed in the correct order.
Check that the opening of the No. 1 fuel injector back-up ring is not overlapped or stretched as shown in the illustration.
After installing the O-ring, check that it is not contaminated with foreign matter and is not damaged.
| *1 | Fuel Pipe Plug Sub-assembly |
| *2 | Gasket |
| *a | Claw |
Install a new gasket to the fuel pipe plug sub-assembly as shown in the illustration.
Make sure that the claw of the gasket faces the fuel pipe plug sub-assembly.
Secure the fuel delivery pipe with sensor assembly LH in a vise between aluminum plates.
Do not overtighten the vise.
Using a 5 mm hexagon socket wrench, install the fuel pipe plug sub-assembly to the fuel delivery pipe with sensor assembly LH with the 2 bolts.
Install a new dust cap sub-assembly to the fuel pipe plug sub-assembly.
Remove the fuel delivery pipe with sensor assembly LH from the vise.
23860
2.INSTALL FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH
Click hereEngine / Hybrid System>7GR-FKS (FUEL)>FUEL INJECTOR (for Direct Injection)>INSTALLATION
Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly LH.
If the fuel pressure sensor is removed, replace a new fuel delivery pipe with sensor assembly LH.
Perform "Inspection After Repair" after replacing the fuel delivery pipe with sensor assembly LH.
Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
5.INSPECT FOR FUEL LEAK