The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure sensor (fuel delivery pipe with sensor assembly LH) removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
23860
4.REMOVE FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH
Click hereEngine / Hybrid System>7GR-FKS (FUEL)>FUEL INJECTOR (for Direct Injection)>REMOVAL
Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly LH.
If the fuel pressure sensor is removed, replace a new fuel delivery pipe with sensor assembly LH.
23809K
5.REMOVE FUEL PIPE PLUG SUB-ASSEMBLY
Secure the fuel delivery pipe with sensor assembly LH in a vise between aluminum plates.
Do not overtighten the vise.
Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.
Using a 5 mm hexagon socket wrench, remove the 2 bolts, gasket and fuel pipe plug sub-assembly from the fuel delivery pipe with sensor assembly LH.
| *1 | No. 1 Fuel Injector Back-up Ring |
| *2 | No. 2 Fuel Injector Back-up Ring |
| *3 | No. 3 Fuel Injector Back-up Ring |
| *4 | O-ring |
| *5 | Fuel Pipe Plug Sub-assembly |
Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe plug sub-assembly.
Remove the fuel delivery pipe with sensor assembly LH from the vise.