The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17111
4.REMOVE INTAKE MANIFOLD
23903
5.REMOVE NO. 3 FUEL TUBE SUB-ASSEMBLY
Remove the bolt.
Detach the 2 clamps and disconnect the wire harness.
Detach the clamp.
Remove the bolt and disconnect the wire harness.
for LHD:
Detach the 2 clamps and disconnect wire harness.
Disconnect the 2 fuel tube sub-assemblies.
Click hereEngine / Hybrid System>7GR-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
Remove the bolt and No. 3 fuel tube sub-assembly.
23801P
6.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe RH and fuel pump assembly.
23100X
7.REMOVE FUEL PUMP ASSEMBLY
Remove the 2 bolts, fuel pump assembly and fuel pump lifter guide from the cylinder head cover sub-assembly.
Remove the fuel pump lifter assembly from the fuel pump lifter housing.
Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.
Remove the O-ring from the fuel pump assembly.