Home › Engine / Hybrid System › 7GR-FKS (FUEL) › FUEL SENDER GAUGE ASSEMBLY
RM35X0E _51 Engine / Hybrid System _079024 7GR-FKS FUEL _0383268 FUEL SENDER GAUGE ASSEMBLY A

7GR-FKS FUEL  FUEL SENDER GAUGE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 83320 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.
A434456C01
0,0 0,0 false
V100135

Slide


Set the fuel sender gauge assembly on the No. 1 fuel sub-tank. Then slide the fuel sender gauge assembly downward until the 2 claws attach to install it.


b.

Attach the 2 clamps and connect the wire harness.


c.

Connect the fuel sender gauge assembly connector.


Hide 77020A 2.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART