Operating the iMT switch illuminates the iMT indicator light in the combination meter. This displays the iMT system standby condition.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Data List
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| iMT SW | iMT switch status | ON or OFF | ·
ON: iMT switch being pressed and held ·
OFF: iMT switch not pressed |
- |
| Tester Display |
|---|
| iMT SW |
| Result | Proceed to |
|---|---|
| Data display is within Normal Condition range | A |
| Data display is not within Normal Condition range | B |
A
B
| *a | Front view of wire harness connector
(to iMT Switch) |
Disconnect the iMT switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N14-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the iMT switch connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N14-5 (S) - E1-12 (MTMS) | Always | Below 1 Ω |
| N14-5 (S) or E1-12 (MTMS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the iMT switch.
Click hereDrivetrain>RC60J (MANUAL TRANSMISSION / TRANSAXLE)>INTELLIGENT MANUAL TRANSMISSION SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereDrivetrain>RC60J (MANUAL TRANSMISSION / TRANSAXLE)>INTELLIGENT MANUAL TRANSMISSION SWITCH>REMOVAL