The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the network gateway ECU removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
83100
3.REMOVE COMBINATION METER ASSEMBLY
89111
4.REMOVE NETWORK GATEWAY ECU
for LHD:
Remove the nut.
Detach the guide and disconnect the network gateway ECU from the instrument panel reinforcement assembly.
Disconnect the connector and remove the network gateway ECU.
for RHD:
Remove the nut.
Detach the guide and disconnect the network gateway ECU from the instrument panel reinforcement assembly.
Disconnect the connector and remove the network gateway ECU.