Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › UREA INJECTOR
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384130 UREA INJECTOR A

1GD-FTV EMISSION CONTROL  UREA INJECTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
A356209

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 51406A 1.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 2.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 51408B 4.REMOVE ENGINE UNDER COVER SUB-ASSEMBLY RH (w/ Cover)

Hide 77840A 5.DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


NOTICE:
·

Check for dirt or mud on the urea injector set and around the urea tube with heater connector before disconnection. Clean if necessary.

·

In order to prevent the urea injector set interior portion from drying, perform installation and removal work as quickly as possible.



a.

Disconnect the urea tube with heater assembly from the urea injector set.

i.
A436322

Detach the lock claw by lifting up the cover.


ii.
A436323

Pinch the retainer of the urea tube connector, and then pull the urea tube connector off of the urea tube with heater assembly.

NOTICE:
·

If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the connector.

·

Be sure to disconnect the urea tube with heater connector by hand.

·

Check for foreign matter in the urea injector set and around the urea tube with heater connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube with heater connector.

·

Put the urea injector set and urea tube with heater connector ends in plastic bags to prevent damage and foreign matter contamination.





Hide 23203A 6.REMOVE UREA INJECTOR SET

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A436325

Disconnect the connector from the urea injector set.


b.
A436326

Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.