To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.
25051
1.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (w/ EGR Cooler)
15677
2.REMOVE OIL FILTER BRACKET
To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.
w/ DPF:
Remove the bolt and wire harness clamp bracket from the oil filter bracket.
Disconnect the connector from the oil pressure switch assembly.
Remove the bolt, 2 nuts and oil filter bracket from the cylinder block sub-assembly.
Remove the 2 O-rings from the cylinder block sub-assembly.
83530
3.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly from the oil filter bracket.