Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › OIL PRESSURE SWITCH
RM35X0E _51 Engine / Hybrid System _079221 1GD-FTV LUBRICATION _0384266 OIL PRESSURE SWITCH A

1GD-FTV LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.



b.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil filter bracket.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after the installation.



Hide 15677 2.INSTALL OIL FILTER BRACKET

a.

Apply a light coat of engine oil to 2 new O-rings.


b.

Install 2 O-rings to the cylinder block sub-assembly.


c.

Install the oil filter bracket to the cylinder block sub-assembly with the bolt and 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


d.

Connect the connector to the oil pressure switch assembly.


e.

w/ DPF:

Install the wire harness clamp bracket to the oil filter bracket with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)