Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › ENGINE OIL COOLER
RM35X0E _51 Engine / Hybrid System _079221 1GD-FTV LUBRICATION _0384269 ENGINE OIL COOLER A

1GD-FTV LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15071 1.INSTALL ENGINE OIL COOLER SET

a.

Apply a light coat of engine oil to 2 new O-rings.


b.

Install the 2 O-rings to the cylinder block sub-assembly.


c.

Install a new gasket to the cylinder block sub-assembly.


d.

Install the engine oil cooler set to the cylinder block sub-assembly with the bolt and 5 nuts.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)